LED's on LFO3 won't light up

[nrgy]

Hello, When I press the select button to choose LFO3, and then Press select again to go down on "osc1,osc2,PW1,PW2 & sync phase on the LFO3 section, they wont light up. Only when I do a change and save it. But when I scroll between thoose functions I can see no light. The LED's work on the other LFO's/MOD, just wondering....this shouldn't be like that? :roll:
Not that it does any harm for me, but I was just wondering/& if anyone else have had the same problem?

Thanks

[udenjoe]

You have to turn up the value of whatever you're modulating. LFO 3 can only be applied to one. I think osc1&2 can be one, and maybe pwm1&2.

[nrgy]

yeah, I know, but when I scroll through the different "osc1" "osc2" etc, there should be a light that shows me on which part I am at? :roll:

[ben crosland]

This is behaving as it should under the current OS. I agree, I think it's a bit confusing - I would prefer that the leds blink if the value is 0.

-=BC

[milty]

Sorry for the "epic thread necro" here but...

Has this issue been resolved? I have a KC and I'm experiencing this.

[milty]

Can anyone at least confirm/deny experiencing this?

[kachanski]

Getting it here too on my virus ti desktop mrk1 latest os.
No Led flashing on LFO 3 whether assigned r rate change applied or not.
Weird