Osc 3 Modes and other missing parameters [UNSOLVED]

[ig88]

word up.

I've searched the forum and read this thread which was very helpful (cheers!) but has only solved one of my problems.
http://www.sunesha.nu/virusforum/viewtopic.php?t=1244&start=0&postdays=0&postorder=asc&highlight=oscillator%20missing%20parameters

I've got a C and in the manual on page 62 it tells me that there are the following 'edit' pages for Osc 3:

Oscillator-3 MODE - ok got this thanks to this site.
Oscillator-3 VOLUME
Oscillator-3 SEMITONE
Oscillator-3 DETUNE
Oscillator-3 PHASE INIT

Which is the same as all the other osc's
Trouble is I only have Oscillator-3 VOLUME regardless of whether I have Osc3 enabled or not.

????

Anyone?

[hatembr]

once u enable osc3 and select it, Detune knob controls the detune amount of it, as well , Semitone knob controls its semitones.
volume is in the Oscillator edit pages, just press edit and go thru the pages until u find "Osc3 Volume"
as far as Phase Init, i think it is the same for all the oscs and it is in the Oscillators page too...

[ig88]

Thanks!

Happy that I can get to the parameters.
Weirded out by the fact that the manual tells me I should be seeing them in the 'Edit' menu.

Can you see these in your Osc Edit menu?
Or is it just me?