record midi cc data from virus to cubase

[gimpoid]

can some one tell me how to record midi cc dataoe equivelent from virus to cubase.
when i press record and say i sweep the filters. then i press play
and nothing.
am i doing something wrong i would much rather record midi rather than large wave files.
anyhelp much appreciated :lol: :?

[gimpoid]

i have midi input and output selected as virus.but when i expand the controler lane there are no virus controllers.

[Onkel Dunkel]

Check that LoPage are set to send controllerdata and not SysEx...

[gimpoid]

just checked the lopage controller and hipage sysex.
was already set like that so think it must be something else.
i am using nuendo 3 is there any know isues with access and nuendo conflict.?

[Onkel Dunkel]

just checked the lopage controller and hipage sysex.
was already set like that so think it must be something else.
i am using nuendo 3 is there any know isues with access and nuendo conflict.?

It doesn?t have anything to do with access since it?s just standard MIDI-controller data when it has left your Virus. Check that incomming controllerdata isn?t filtered in Nuendo (check that Nuendo is set up to record controllerdata, i don?t know how this is done in Nuendo) and make sure that the channel on the Virus is the same channel as you are recoding on in Nuendo.

Edit: By the way: Make sure that SYSTEM->MIDI->Panel is set to "Int+Midi" or "Midi" or else your knobs won?t send tweaks out via MIDI...

[gimpoid]

ACCESS VIRUS B DEKTOP SETTINGS
midi dump tx = arrangement
midi dump rx = enable
midi global channel = 1
midi panel = int+midi
midi arpeg send = off
midi clock rx = auto
midi volume = enable
midi progchange = enable
multiprgchg = enable
midi device i.d = omni
lopage = contr
hipage = sysex

[ben crosland]

It'll most likely be that Nuendo is filtering sysex. Check the Preferences>MIDI

[gimpoid]

NUUENDO 3 PREFERENCES->MIDI

midi controller input to automation tracks = yes
midi thru active = yes
reset on part end = no
reset on part stop = no

CHASE EVENTS

note = yes
pollypressure = yes
controller = yes
programme change = yes
after touch = yes
pithcbend = yes
sysex = yes

NUUENDO 3 PREFERENCES->MIDI->MIDI FILTER

RECORD
note = no
pollypressure = no
controller = no
programme change = no
after touch = no
pithcbend = no
sysex = yes

THRU
note = no
pollypressure = no
controller = no
programme change = no
after touch = no
pithcbend = no
sysex = yes

[gimpoid]

i dont know if these nuendo settings are correct i have reset them to default.
i am fairly new to nuendo/cubase.

[gimpoid]

does any one know the meaning of CHASE EVENTS in nuendo 3 pref
i have searched every manual with nuendo and cannot find a definition, or know if my settings are correct