Can't find my multi setup when i load Virus Control...

[7G]

Ok this question might be stupid....I made a track using Virus TI as an external hardware(plugged the outs of TI into my Powerbook line in)...Now, i want to make this exact project with Virus Control but when i load Virus Control all the parameters on my multi are getting initialized and i can't find where my multi are...Could anyone explain how can i find my multi's-that i've stored in TI's hardware memory- in Virus Control?

[ben crosland]

The Virus Control does not support standalone Multi Mode. Try saving the patches from each part to RAM locations, then you'll be able to load them into VC.

[7G]

Thanks Ben for your quick reply...You tha man...I will do exactly what you've told me...