Lost my sounds

[diy]

After I've loaded vengeance sounds in ram d via usb (via midiusb output virus ti midi,without Vcntrl) my saved sounds into ram a became silent patches. Even if I tweak the oscilators,filters etc I get no sound at all. This must have happened after loading virus control and re sync all the new patches from ram d which seems ok. After that mess I had problems with midi (not receiving any messages both ways,via usb and midi cables) I rebooted and then I saw half screen with random dots here and there, like it was broken. After the usual arp edit reset everything seems ok, but I dont know what to face next time. Tell me please when the next update is coming!!! :x

[ben crosland]

Actually, I think this may simply be because you have used the wrong midi port. Virus TI MIDI does not address the Virus itself, but the midi out port - you should use Virus TI Synth.

Still, if this doesn't help, please send me the files I requested in the pm.

[diy]

Thanx for the quick reply Ben, you are definitly right about virus ti midi over usb, reloaded the whole ram A via midi and everything's fine now. By the way,which files have you requested?

[ben crosland]

I just wanted to check your RAM banks, but it seems this isn't necessary now, so don't worry about it.

[diy]

After 1.0.8 update and after loading Vcntrol again, all my ram banks have gone crazy. In the first patches from ram a to d appeared the patches overture ck and hallo sequentially which have virus c like assigment on the soft knobs(only 2 parameters). Thank god I've backed up everything....