Noise on Snow

[soulidstate]

Hi,
I have got a Snow connected to the inputs of a Triton Extreme. It produces so much noise when I turn it on. The Extreme is quiet alone but becomes noisy when I turn on the Snow. Any of you guys experienced this?What could be wrong?

Thanks
Regards

[Smoothound]

If it's a mains type hum, could be a ground loop. Try dropping the ground connection from one of the devices (but be sure to put it back if you try to run the device on it's own!);)

[LivePsy]

Is it the Triton valve on high gain? Other thoguht is, are you using the official Access chinese brand of transformer, because other compatible transformers can put a whiney noise on the sound.

Cheers,
B

[soulidstate]

Is it the Triton valve on high gain? Other thoguht is, are you using the official Access chinese brand of transformer, because other compatible transformers can put a whiney noise on the sound.

Cheers,
B

I tried turning off the Valve but the noise is still there. I dont think it's the Triton as I have the same case with my FantomX6 when the Snow is connected. I am not sure if it's a chinese PSU but the brand is PUT POWERTECH,Inc. Have you has the same problem?What did you do?
Thanks

[LivePsy]

My only noise issue was a whine (about 1000Hz) when I used a high quality dc adapter. So I used the original PSU and the noise went away. But if you get it connecting to your X6, it sounds like the outputs are noisy on the Snow. Are you talking about hum, buzz or white noise?

Cheers,
B

[soulidstate]

My only noise issue was a whine (about 1000Hz) when I used a high quality dc adapter. So I used the original PSU and the noise went away. But if you get it connecting to your X6, it sounds like the outputs are noisy on the Snow. Are you talking about hum, buzz or white noise?

Cheers,
B

It's more like a white noise.

[Juho L]

a) What outputs you use?
b) Is the TI noisy even when you connect it directly to the PA/Mixer/etc?

[soulidstate]

Hi all,

I contacted Access Support.Joerg told me to detach connections including power. Put back the PSU and press TAP TEMPO button. I then turned it on. The noise is GONE!!!

Excellent support from Access. Got a response in less that 12 hours!!

[soulidstate]

a) What outputs you use?
b) Is the TI noisy even when you connect it directly to the PA/Mixer/etc?

Hi Juho,

I use the analog outs which are connected to Triton Extreme's audio inputs which is hooked direct to speaker monitors.
I tried connecting the TI directly to the monitors but got the same result.

Anyway, I am happy and satisfied with my SNOW now. Thanks for all the attention given to my post.