Noise Color in Virus Ti

[phyler.exe]

Hello guys


I had a virus KC a while back and recently got a TI keyboard.

..Damn if I can find 'noise color' as parameter! Where is it?

It's in the modulation destinations but for my life I can't find it anywhere else. In the C series it lived in the OSC edit menus I think.

Thanks a bunch!

[Timo]

Hi Phyler :)

Hello guys


I had a virus KC a while back and recently got a TI keyboard.

..Damn if I can find 'noise color' as parameter! Where is it?

It's in the modulation destinations but for my life I can't find it anywhere else. In the C series it lived in the OSC edit menus I think.

Thanks a bunch!

Just to confirm, on my old Indigo it's in the Oscillator 2 section of the fascia, too. I press the Edit button and then scroll left/right with the parameter cursor buttons, and Noise Color is one of the options.

By the sound of it it has been moved on the TI?

[phyler.exe]

Timo,


The OSC2 pages, yep that's what I recall from the KC. On the TI there's only oscilllator parameters on the OSC pages, no nuttin' about noise. I have looked in the filter pages, the pages common for the patch (where you find unison and patch volume etc)

I do hope that it's beena *moved* somewhere and is not *absent* save as a modulation destination. Any other TI users?

I'm bugged because I used to do sounds where I 'highpassed' the noise before passing it to the filters along with the oscillators..

[phyler.exe]

...according to the TI manual page 124, it has it's own page in the OSC section, however COLOR only shows up when NOISE VOLUME is > 0.

Tsss. I'll see about that. I... I... no.. I would have noticed... 8o)