Help needed.....

[synthfiend]

Can someone tell me whether it is possible to use the TI as your sound card (with the USB outs selected in VC, ie using the latency compenastion in Live) and route the audio generated by the TI out analogue output 1 and the audio generated from your DAW (Stylus RMX within Live in this case) out the analogue out 2 on the TI.
I would then run analogue outs 1 and 2 from the TI through an analogue mixer.
This way both Stylus and the TI are synced properly and I can use analogue summing.

[ianfoxfire]

My TI Snow acts as a sound card no problem. I have even use its outputs for winamp, etc.... I find it has very low latency.

[synthfiend]

thats not really my question, but thanks anyway.

[Ronkaz]

you could do it the other way round:
set the patch in VC to OUT 2 and send the output of the DAW to OUT1

r

[synthfiend]

Thanks for the hint, I will give that a go.
I noticed that when the TI is selected as your sound card within Live that the Audio preferences Output Config only gives you the option of Output 1. So if I select Output 2 for the parts in VC it should split the sound over two of the three analogue outs on the TI.

I guess what I am trying to do is map the USB outs to the analogue outs.

Thinking back I think I did select USB 2 out for a part and had no audio coming out of the analogue 2 outs. Anyway I will give it another go.