Why does TI(2) always fall back to SINGLE mode?

[dgls]

Not only does the TI2 always boot up in SINGLE mode, it does not respond to the Sysex message to switch to MULTI mode the way the Virus B and C do.

I use the TI2 connected to DAW via USB. I have to always press the MULI mode button every time I boot the DAW. I hate this.

I have never heard this mentioned online. Do people just put up with this, or is there a workaround?

[dgls]

Can anyone else comfirm this is the case for them?

i.e The Virus TI2 powers up in SINGLE mode and cannot be put into MULTI mode with a sysex message?

thanks

[StudioDeutz]

Hi there,
I own a Ti latest patch level.

If I switch to Multi, it comes up in Multi Mode.
But I am not a DAW user and the USB is only connected for saving data.
My MPCX is the master in standalone (by far not perfect...) for recorded midi data and changes to parameter.


I am currently digging deep in the parameters of the Ti - tiresom job, as Access has no secure list of it available for public. And it has changed between the different editions too.
I am configuring my Bitstream 3X, I just purchased 2nd hand, to have more control of the inside of the Virus.
I tried to find out which parameter is responsible for changing between the two modes - was not successful as yet.


Good luck,
R.

[dgls]

Thanks for your reply.

When you switch the power on the TI is the synth always in SINGLE mode?

There is a short sysex message string that puts a virus into SINGLE or MULTI mode which I have used with my Virus B and Virus C, but it does not work on the TI2 :(

[StudioDeutz]

Thanks for your reply.

When you switch the power on the TI is the synth always in SINGLE mode?

There is a short sysex message string that puts a virus into SINGLE or MULTI mode which I have used with my Virus B and Virus C, but it does not work on the TI2 :(


no, my Ti (not 2) comes up in whatever I left it in - Single or Multi.


What is the sysex code you used?
As mentioned, they've changed some parameter....

[dgls]

If I send { 0xf0,0,0x20,0x33,0x01,0x10,0x72,0x0,122,2,0xf7 };
to my Virus B port, it will go from SINGLE to MULTI.
If I do the same to my Virus TI2, it stays in SINGLE.:(

Has anyone else noticed this issue?