The Unofficial Access Virus & Virus TI Forum - since 2002

The Unofficial Access Virus & Virus TI Forum - since 2002 (http://www.infekted.org/virus/forum.php)

- General discussion about Access Virus (http://www.infekted.org/virus/forumdisplay.php?f=105)

- - stupid question on virus knobs (http://www.infekted.org/virus/showthread.php?t=25276)

Quote:

Originally Posted by blay

Quote:

Originally Posted by Timo

Slightly OT, I've now aquired two new pots to replace a couple of wobbly pots on the Virus. Got all the soldering equipment ready, now just trying to psyche myself up to actually do it sometime.... Will require many deep breaths!!

good luck with it timo...

perhaps you could post some pics of the adventure?

For sure. ;)

Thanks

Thanks for the answers, I'll give it a try later.

Quote:

Originally Posted by blay

Quote:

Originally Posted by Timo

Honestly, they just slide off. And then slide back on again.

i think saba was referring to the fact that HC managed to remove one while playing :wink:

blay

When you're getting into it, you're getting into it - if you know what I mean. :wink: You should see the mod wheel and bender on the Nord - absolutely thrashed! :D Should say "worn in" rather than thrashed....

Knobs do come off the VC easily. The reason why it came off in my case was because I had it tilted on an angle though - I never put sideways presure on pots.

Bad luck Timo. Having the knobs rubbing is no way to go. Hope you figure something out.