It was a test project which I've deleted but I can make a new soon.

Everything seems to be OK...Had a small Graphic problem on the Virus control while changing from Osc page to Easy page some of the Graphics stayed from the Osc page making the Easy page look abit strange (Double graphics) apart from that...Great stuff

is the midi timing any better for MIDI 1/4inch jack crew?

we are not aware of a MIDI timing problem using conventional MIDI. if you have a problem, could you please send a project which illustrates the problem to me (ms [at] access-music.de)?

Marc,

it was very funny to post the "Nuendo is not supported" in the Nuendo forum. All members were completely sure that it should be no difference between SX and Nuendo. Hehe ! Good that Midi_Glider found this difference...

Hmm. Not too funny, to be honest. Is there any chance that Nuendo will be supported or is the problem inside of Nuendo ?

I can?t use SX because it simply doens?t offer the post production features I need. But of course, the TI works great with SX. A bad situation.

Regards,
Matthias

Cant say Ive noticed any difference using the TI in Nuendo or SX.

ten

Oooops. Which MIDI-interface ?

"are not aware of a MIDI timing problem using conventional MIDI. if you have a problem, could you please send a project which illustrates the problem to me (ms [at] access-music.de)?"

I'll send one through, but it's every project I work on,

Basically Midi timing will drift out of sync after you have a few bars in cycle and it's cycled round maybe 2 times.

I use it via usb only.

ten

hmmm...is that true for arp playing\exports as well?

or perhaps its SP2 related? marc mentioned something about the TI requiring SP2 for Nuendo.

What service pack are you on, Matthias?


Best,
midi.