Reset Volumes when turning my virus back on
 

Is there any way to stop the virus reseting every channels volume to maximum when you turn it on. every time I start Logic I have to slightly move the volume faders so that the virus's volume on each midi channel goes back to how I had it before!

Cheers!!!!!

I think this should be fixed when you save your multi and when you load the project, you also load the multi again.

Perhaps its program reset messages being sent at the end of a song / opening of a song / start of a song.
________
CHILD NEXIUM

Yes. I believe Logic sends volume changes when it's started. That's why the only way is to save the multu (or unplug the MIDI cables during Logic startup, but that would be too difficult).

Is saving the multi done in the same place as saving the arragment?

and if so would you have save both multi AND arrangment??