Alternative outputs on Rack XL [solved]
 

Been a while since I posted in this sector.........

But I guess even the most brilliant minded people run into trouble sometimes.....hehehe

I have been noticing a little bit of noise/hum lately, and after a little investigating, I came to the conclusion that it was originating from the outputs of my Virus Rack XL.

My question is, can I change things around so that all sounds will also be sent to the 2nd outputs, so I can just use them instead? I am about to go digging around the manual, but thought I would post the question incase anyone here had a suggestion for me.

Thanks!

Jase.

edit: All good! I went to the ARP/system menu, set the 'second output' balance to 127, and then selected the second output "select out2 L+R".

Did the hum disapear?

Well....yes & no. The hum is still there, on the main outputs of the Virus, but since I am now using the second outputs, the hum has gone away.

Problem solved, all by myself too! Are you proud of me? hehehe.....

Ummm.....Spose so.....