Virus C Arpeggiator doesn't work correctly
 

As I am new to the forum : Hello to every1!

I couldn't find anything for this in the forum.

If I am triggering an Arpeggiosound from Cubase SX it seems that the Virus and SX are not running exactly at the same speed.

Let's say I just trigger a cycle of one bar (via Midi) it stops randomly every 2nd 3rd or 4th bar. and begins to be regtriggered after the next cycle.

It doesn't matter which Arpeggiator-Pattern I use. The speed is at the same value.

Any known issues for this?

Sorry for my bad explantion. I am from Germany!

Regards, Sebastian

EDIT: I could add a new picture to the Avatar but the old one with the stupid baby didn't remove. So there are two pictures. What to do? Thx!

Welcome to the forum!

The baby pic will disappear after your next post.

Perhaps try posting on the Steinberg Cubase forums too, as it might be something with SX, and they may have some hints.

Sorry I couldnt be of more help!

Good luck!

:)

make sure your virus is set to sync to incoming midi clock and that cubase is the master.

Hope that helps

Re: Virus C Arpeggiator doesn't work correctly
 

Welcome :D

Try going to the "Config" menu and set the tempo(clock) to the tempo of your song. It teases me sometimes because i havent figured how to make it automaticly sync to sx. You should try it.

I agree with Gopal. Make sure you use midi clock sync and set SX as the master. You can find the midi clock sync in sx under the transport menu.

Thx for your replies so far!!

I'll check everything and tell you if it works properly then.

Has noone had this prob. so far?


Sebastian

Hi!

I did it like u suggestet it.

I made SX sending Midiclock to the Virus. SX is also the master (it was the master before also )

The Virus indicates (by a little "c" in the display) that it gets Midiclock from SX and the virus also follows tempo-changes in SX but the failure is still the same.

Don't know what to do. :cry:

Thx for your replys!

Seb.

Sure like an odd problem.

Is everything connected right, is there any options in Cubase you missed out on?

Hallo Sebastian,

das Problem das Du hast nennt man Latenz, Dein Virus ist von der BPM her warscheinlich perfekt gesyncht, Du sagst ja selber das C erscheint auf dem Display ... Wenn Du aber am Rechner startest h?ngt der Virus ein bissel hinterher (ganz normales Problem, haben wir mit unserem Virus b & Ableton live auch) :wink:

ein schau mal in den Cubase MIDI-sync Einstellungen, dort m?sste man iwo die Latenz in Millisekunden einstellen k?nnen - Du kannst den Wert positiv und negativ beeinflussen - je nach dem ob der Virus zu schnell oder zu langsahm ist ... wenn Du jetzt also -4ms einstellst dann wird der Virus 4 Millisekunden eher zu spielen anfangen als Cubase bei +4 nat?rlich 4 Millisekunden sp?ter - ganz easy, probier einfach ein bissel rum bis es passt.

THE GERMANS ARE COMING!!!!