record midi cc data from virus to cubase
 

can some one tell me how to record midi cc dataoe equivelent from virus to cubase.
when i press record and say i sweep the filters. then i press play
and nothing.
am i doing something wrong i would much rather record midi rather than large wave files.
anyhelp much appreciated :lol: :?

i have midi input and output selected as virus.but when i expand the controler lane there are no virus controllers.

Check that LoPage are set to send controllerdata and not SysEx...

just checked the lopage controller and hipage sysex.
was already set like that so think it must be something else.
i am using nuendo 3 is there any know isues with access and nuendo conflict.?

It doesn?t have anything to do with access since it?s just standard MIDI-controller data when it has left your Virus. Check that incomming controllerdata isn?t filtered in Nuendo (check that Nuendo is set up to record controllerdata, i don?t know how this is done in Nuendo) and make sure that the channel on the Virus is the same channel as you are recoding on in Nuendo.

Edit: By the way: Make sure that SYSTEM->MIDI->Panel is set to "Int+Midi" or "Midi" or else your knobs won?t send tweaks out via MIDI...

ACCESS VIRUS B DEKTOP SETTINGS
midi dump tx = arrangement
midi dump rx = enable
midi global channel = 1
midi panel = int+midi
midi arpeg send = off
midi clock rx = auto
midi volume = enable
midi progchange = enable
multiprgchg = enable
midi device i.d = omni
lopage = contr
hipage = sysex

It'll most likely be that Nuendo is filtering sysex. Check the Preferences>MIDI

NUUENDO 3 PREFERENCES->MIDI

midi controller input to automation tracks = yes
midi thru active = yes
reset on part end = no
reset on part stop = no

CHASE EVENTS

note = yes
pollypressure = yes
controller = yes
programme change = yes
after touch = yes
pithcbend = yes
sysex = yes

NUUENDO 3 PREFERENCES->MIDI->MIDI FILTER

RECORD
note = no
pollypressure = no
controller = no
programme change = no
after touch = no
pithcbend = no
sysex = yes

THRU
note = no
pollypressure = no
controller = no
programme change = no
after touch = no
pithcbend = no
sysex = yes

i dont know if these nuendo settings are correct i have reset them to default.
i am fairly new to nuendo/cubase.

does any one know the meaning of CHASE EVENTS in nuendo 3 pref
i have searched every manual with nuendo and cannot find a definition, or know if my settings are correct