Lost my sounds
 

After I've loaded vengeance sounds in ram d via usb (via midiusb output virus ti midi,without Vcntrl) my saved sounds into ram a became silent patches. Even if I tweak the oscilators,filters etc I get no sound at all. This must have happened after loading virus control and re sync all the new patches from ram d which seems ok. After that mess I had problems with midi (not receiving any messages both ways,via usb and midi cables) I rebooted and then I saw half screen with random dots here and there, like it was broken. After the usual arp edit reset everything seems ok, but I dont know what to face next time. Tell me please when the next update is coming!!! :x

Actually, I think this may simply be because you have used the wrong midi port. Virus TI MIDI does not address the Virus itself, but the midi out port - you should use Virus TI Synth.

Still, if this doesn't help, please send me the files I requested in the pm.

Thanx for the quick reply Ben, you are definitly right about virus ti midi over usb, reloaded the whole ram A via midi and everything's fine now. By the way,which files have you requested?

I just wanted to check your RAM banks, but it seems this isn't necessary now, so don't worry about it.

After 1.0.8 update and after loading Vcntrol again, all my ram banks have gone crazy. In the first patches from ram a to d appeared the patches overture ck and hallo sequentially which have virus c like assigment on the soft knobs(only 2 parameters). Thank god I've backed up everything....