Changing program
 

Has anyone understand how the button combination works for the "VALUE"-knobs ( + and -) if You wan't to jump from program 127 to 0. :?: ( ..and from 0 to 127)

When the current program is 127, and I clicking the "+" and so "-" result
sometimes a progam change from 127 to 0, but it also goes to program 64, or it only counting down thru all the programs.

I wan't full control over this, but I can't find it out, because it get different results.

....hmm where's the usermanual :?: 8)

Nothing about this "advanced program change" in the manual, but I found the funny "SHIFT" + "STORE" combination , randomizing patch :? , so that's the way to make cool patches :P

(and another thing, the "ROM-Q 114 ThickSawJL " is sounding goooooOOOOOOOoood!! :!: )

Solution for changing program from 0 to 127 : 2 fast clicks (10mS each): one short click on "VALUE +" followed with a short "VALUE -" , now it work nearly every time ( some 64)

If you're at 127 and want to get to 0, press "-", hold it, then press "+", let go of "-" first. It's sort of a rolling motion once you get the hang of it.

Opposite for going from 0 to 127.

The PDF version of the user manual is included with every TI OS installer BTW.

Guzzy

For fast patch changes try holding the red shift button (next to transpose) and the value 3 knob (program). Also shift + Value 2 knob (bank) and shift + Value 1 (category).

The small red text is difficult to see - should be in yellow IMO.