Korg Kaoss 2 Pad w/ Virus TI
 

So.....I got this here Korg KP2, I'd like too use it with my TI......but the KP2 doesn't send on 40-44(The Filter numbers) :x . Do I got to do some midi dumping or sys ex???? Any help or pointing to an eariler thread would be much, mucho apreciated. This fucking Kaoss pad is gathering dust!!!!! :roll:

Re: Korg Kaoss 2 Pad w/ Virus TI
 

ian-

It is not so much that you need to do midi dumping or sys ex, as it is to "reroute" the cc#'s to respond to the same funtion on both the TI and The Korg. I don't own either so I can't tell you if your harrdware is capable of it.
I can say that I have performed the same functions with different gear, and Access virus powercore.......mapping my oxegen 8 so I can automate filter sweeps, etc...
I know in digital performer, there are continous data and controller options to filter these messages and redirect them to the appropriate cc#. While a host sequencer makes it easy, I doub't that it can't be done hardware to hardware......

Apparently with the help of the mod-matrix, I send X to CC1 & Y to CC2 then in the matrix appoint CC1 to say.....CC40, and CC2 to CC 41. This has to be done per patch, but three sends can be sent per slot. :shock: So I can tweak the filter cutoff, the FM amount & modulation with one lateral slide of the finger! :D Yay! Sorry, but this manual does me little good if I don't have the proper context to apply it with.

maybe the kaoss pad is better of collecting dust after all :P

ps, I wish you had a bass amp, I have run into a "possible" drummer.

Sometimes you have to leave the manual behind and think creative. Especially when it comes to making different brands of gear work together...

Onkel Dunkel is a wise, wise,....... scary babydoll?
cheers nailgun
PS my kaos pad is also collecting dust.

KP3 being released in October.....


hopefully the fuckers have it sending on all CC#'s!!!!

http://www.korg.com/gear/info.asp?A_PROD_NO=KP3