LFO Question
 

This may be a retarded noob question, but I;m trying to modulate.. lets say filter cutoff with an LFO. I want it to sweep down and stay down, but I can't figure out how to do it. In envelope mode, for instance, I can get it to sweep down but it always completes the cycle and comes back up. How do you get it to stop halfway, so-to-speak?

Set the LFO to triangle, activate envelope mode and set contour so that the triangle is transformed to down ramp saw. To get the down ramp saw set the contour to either maximum value.

...or set the LFO to saw and turn envelope mode on.

Ach. Forgot that Virus have saw LFO. My memory isn't quite the same it used to be. Ähih.

Works good! Just when I start to think I have this analog modelling stuff down something comes along to remind me how noob I really am.