Sample rate change: Arp sync gets bad.
 

I've had a good run with the TI for over a year now but I usually work in 88.2Khz. Then I started two remixes a 44.1Khz and got them upto 90% done.

Then went to load them recently and the ARP timing is all up the SH#$T.
Couldn't even listen for two bars with out the BPM light going slow,, stop,, really fast,, slow,, fast,, stop,, slow etc.

I could only get OK timing again by switching the project in Cubase to 88.2Khz.
When I say OK timing, it could be better, so I still have a slight problem. Can anybody shed some light on this one?

This is bizarre as when I started in 44.1Khz the timing was rock solid for about a week.