Virus Help!
 

Hi fellow infekted people:)

I seem to have aproblem with my new snow.

I installed everything and when i try to use to usb outs, FL Studio doesn't recognize them in the mixer. It only recognizes the analog inputs. And unless I use the Snow as my Asio interface, no inputs or outputs can be selected.

Oh and I have to re-install the drivers alot:(

i love my snow but if I could get my problems sorted out it would be my perfect synth.

Can anybody help?

I've read about a lot of people who has problems with the TI + FL combination. Did you check if FL is supported by the TI? I can't find the compatability list right now, but I'm not sure FL is on there. However Cubase SX 2 isn't either, but I've had it working fine in that...

add the VC plugin to FL ... open it and goto COMMON tab
there you should be able to change the output channels for each part.
if the channels shouldn't be detected, you have to add them manually.
got not that much clue of FL ... but this is the usual procedure.

I checked the compatibility list and it said FL 7.4.

I checked mine and it was 7.0 so I upgraded to 8.0 and it works but has some bugs.