out of tune AGAIN!
 

I am using 3.0.1.09 and once again.

I have double checked this with the tuner logic.

Part B C D are in tune, however part A is two semitones out of tune !

Im going to roll back to 2.7.5 and then try 3 again to try and sort this out

Can any of you check if you have the same issue.

BTW im using Snow.

just unplug the snow and boot it holding Tap Tempo Key should solve it. in case it happens again, try to remember what happened right before. i'd be interested to learn how to reproduce this.

thanks, marc

rolled back to 3.0.1.06. it worked

however it has gone out of tune again. all I have done is flick through patches

how exactly were you flicking through patches? in VC with the mouse or with the cursor keys or one the hardware using the +/- buttons?

cheers, marc

Hey Marc,

I was using VC, however I was using the cursor keys on my keyboard to flick through the patches. Once I have selected the first with the mouse, just pressing the down key is alot quicker then double clicking each one.

Hope this helps

I had a similar problem once.
I dont know what DAW ur using but in case you are using one of the usual suspects, try to load a project, can be a new one or autoload or whatever, and have the virus on as well, than change the samplerate in your daw.
Going from 44,1 to 48 and back to 44,1 solved it.
Never had a problem again.

Nice, I will try that next time.

The problem was evident in both Logic 8 and Live 7

I had that problem in Logic 8, so this might be a good Idea.

good luck