Printing MIDI parts from the Snow
 

I'm having a problem determining what outputs parts 1-4
are assigned to while using TI. I have a piece that is using all 4 parts on the
Snow. I have parts 1 and 2 assigned to USB1 and parts 3 and 4 assigned to USB2. When choosing the inputs of my audio track to print to the only available options in Digital Performer 5 are "Snow 3-4" and "Snow 5-6" I can only print parts 3 and 4 from USB2 (one at a time naturally). I had to change parts one and two to the analog outs and use my audio interface to print parts them.

So.....
- Where the heck is "Snow 1-2"? I'm assuming it's assigned to USB1, no?
- Just what parts are assigned to "Snow 5-6"
- Is it possible to print all four parts to different tracks at a time
(I'm guessing not since there are only three stereo outs.)

Any help would be very welcome.

Thanks,
Mark