No sound on the TI2 in SEQ mode
 

This problem birthed a few hours ago. Despite re-installing OSs 3.0.3 or 3.0.4, the problem persists. No sound comes out in SEQ mode from channels 1-16. The weird thing is it's good in Single and Multi modes. I use a Korg M3 and have been using this HW combination so I am sure there is nothing wrong with the M3 as when I play notes in SEQ, the note symbol appears at the lower right corner of the TI display so it's receiving midi data.

Anyone who has a suggestion? I have reported this to Access Support a while ago. Hay, when will my plight with this expensive gear end???This is very frustrating.

Have you tried a global reset by powering on with ARP EDIT held down?

Hi Ben.That did it!Didn't know about that yet.I thought it was the Tap button that does it because that was what I was adviced to do when I still had my Snow.Thanks very much.