Anyone here uses the Virus TI as soundcard?
 

Hi,

Anyone here uses the Virus TI as soundcard?
i am trying but can not get the job done.. :-(
All TI (Snow) software is installed and my Virus works as vsti in Cubase 4.
When i switch the ASIO to Virus TI ASIO and connect my KRK speakers to the output L + R of the virus, i do not hear a thing :-(
what am i doing wrong?

thank you!

Two things to check:

1) Main Volume Knob?
2) Possibly using VC and I/O Config is set to "3 Outputs/1 Input"?

r

1.Volume knob is open.
2.IO config is set to 3 Outputs/1 Input

still no sound :-(

the strange thing is, it just worked! for 1 time... :-( now when i open the same project, i dont hear a thing...

this is what i did:

1. Open Devices > Device Setup…

2. Select VST Audiobay.

3. Set the Master ASIO Driver to Access Virus TI
4. Set the audio buffer to a value of 512 Samples

When i start cubase and load an empty project with the following settings:
Devices > Device Setup : Set the Master ASIO Driver to Access Virus TI
DEVICES -> VST CONNECTIONS : TI Snow outputs

I can hear the sounds from my audio files and or vst instruments.

BUT

when i load an old (finished) project file (made with my RME FF400 interface), with the same settings mentioned above,
there is no sound at all... :-(
Even, when i close the finished project and load a new empty project again and import an audio file, the new project also wont give me any sound..
when i restart the TI Snow (turn of and on again), i can hear the new, empty project with 1 audio file again, but still no sound when i load an old project file.

I really want to open my old, finished projects again! I even uninstalled all the RME FF400 drivers.

thank you.

Since it's Cubase 4. Have you checked your Control Room settings? Cheers