Connecting multiple TI's and using VC
 

Hi,

I know it might be an odd question, but I may be in a fortunate enough position to purchase a second TI, the desktop to go with my KBD. Looking to double up on the power of my home studio and I love my TI2 so much that the idea of having more of the same in there and pretty much running the majority of my project through Virus h/w is very appealing!

Is it possible to connect more than one Virus TI to a single DAW using VC?

I know you are only usually able to run one instance of VC in your project, so I am not sure if this would work!?!

Also, I guess that if youi could get round the VC side of it, you would need more than one dedicated usb bus (2 usb cards) due to the bandwidth one Virus occupies? I think my usb bus runs at approx 73% utilization.

Anyone done this or perhaps know if it is possible to do?

Thanks,

Simon

Sounds cool !!!!!! Dont know its possible but cool

I wonder if the access guys can answer this one? Must surely be possible to harness more than one virus on one system. Perhaps when two are connected you can simply start two VC's?!!

Obviously you would need to have two dedicated usb busses, as one bus is 73% utilized by a virus when connected.

Just wondered if the software would allow it?!