hi everyone.....
i haven't been able to figure this one out, but should be straight foward i think.
i want to record automation on my virus with logic 5 (PC)
i hit record and while its recording i move a knob on the virus.
that works fine....
now, say i want to go in and edit the automation precisely.....
the only way i know how is to pull up the "EVENT LIST" which is a list of the values and parameters for the sys ex, and then i would have to change values between 0-127....
is there any way to do this graphically, that would be much easier and faster......
please let me know
thanks
