[sputnikcdn]

hello,

I work with a hardware sequencer (yamaha rs7000) and typically insert a program change command at the beginning of each track to ensure the synths are correctly set up.

I've figured out how to select a patch on the virus in single mode using a program change command ( for ex. PC 000-001-008 would select patch 8 on bank b).

But I can't figure out how to work with multi mode.

When I switch to multi mode on the virus, a sysex command is sent to the rs7k. I've recorded that and sent it back to the virus, but it did nothing.

So, can anyone tell me the program change, cc and or sysex commands that I need to send from my hardware sequencer to the virus in order to make the virus go into multi mode and pick the multi i need?

Then, for each track, I need to be able to change and/or select the single from the rs7k.

Thanks for any help,

regards,
Paul