Hey Jasedee,
My problem is that I cannot get more than one sound to play at the same time on the same channel.
I followed Onkel Dunkel's instructions below last night:
Quote:
Onkel Dunkel wrote:
> Select multi-mode
> Press "system/multi edit"
> Press "parameter" until the display says "midichannel" and a number
Alex:
[THE DISPLAY LOOKS LIKE THIS NOW:]
1 MIDI
GlobalChan 1<
> Select the part (by pressing"part") you want to assign a midi-channel for
Alex:
[EVERY TIME I PRESS PART THE MIDI CHANNEL INCREASES BY +1]
> Select the midi-channel you want to use for this part
|
OK, here is where I am stuck.
If I press the PART keys the MIDI channels go up or down
If I press the VALUE keys the GlobalChan goes up or down.
How in the hell do I select the patch I wish to assign to any of these channels?
I don't want to assign a different patch to 16 different channels.
I want to make two or three sounds play at the same time with the pressing of on key; so I only need one MIDI channel, right?
DO I have to get into Multi-Single Mode to do this?
Right now I am in Multi Mode, it seems this is the mode to use with a sequencer if I am assigning different sounds to differnet channels.
Does this make any sense?
Sorry for being a blockhead!
I'm sure once I understand this I will fell liek a complete dipshit for taking so long to figure it out.
Time to mess with the manual some more...
PISS!!!
-ALexHall74