Quote:
|
Originally Posted by AlexHall74
...the tricky part was assigning a patch to each part.
|
If you use Multi/Single mode you can assign a patch to the active part as if you where in Single mode and then change the part (by pressing "Part") and then select a new patch etc.
Example:
- Set up the parts MIDI-channels as descibed earlier.
- Press "Multi" and "Single" simultanously to enter multi single mode.
- Select part 1.
- Select disired patch for part 1.
- Select part 2.
- Select disired patch for part 2.
- Select part 3
- Select disired patch for part 3
- Etc.
You get the point...