Installed ok on a MacPro 10.5.6 with Logic8.02 with 3.0.115 running on the TI desktop. Firmware upgrade went through fine and then restarted. Then kicked off logic and it started scanning the two new components - then unexpectedly OSX popped up the hold the power button down hard-reset message.
So I restarted, loaded up logic, started scanning the components again, and seemed to take about 30 secs with the virus flashing a few times - screen and LEDS. then it loaded up fine into Logic.
Is the Virus Control Centre new? Never noticed that before.
So far so good otherwise..
