View Single Post
  #2  
Old 10.10.2019, 10:14 AM
mentataudio mentataudio is offline
New here
New here
 
Join Date: 02.10.2019
Posts: 3
Default

Did you ever give these a go? I am tempted too and my Indigo 2 is pretty noise on 1+2 and the headphone output.

With the lifted pad, can you trace where it goes to on the tracks on the board and solder a piece of wire from the component leg that would go on the lifted pad to the destination? I lifted a pad slightly on my Yamaha RM1x and found just soldering it anyway worked, but not sure how advisable this is.
Reply With Quote