View Single Post
  #1  
Old 17.11.2020, 11:39 AM
charonme charonme is offline
Definately caught something...
Very mucho Newbie
 
Join Date: 11.10.2016
Posts: 36
Default TI2: browsing through LFO assign target modifies parameter permanently

When I load a multi program (16 or higher) and then browse through the LFO 1 or 2 "assign target" options (even when amount is 0%) many of the single patch parameters are permanently modified (mostly set to 0) or sometimes even a permanent LFO modulation is somehow applied on some of the parameters. This doesn't happen if the single patch is reloaded from the banks beforehand. Also it doesn't seem to happen with multi programs <15. Factory reset didn't help.


Last edited by charonme : 09.02.2021 at 01:18 PM.
Reply With Quote