First of all, thanks for your interesting hollow!!
I am going mad about this trouble...
Here's my settings:
Midi Dump TX -> SingleBankA
Midi Dump RX -> ForceToBankA
Midi -> GlobalChan 1
Midi -> Panel Int+Midi
Midi -> ClockRx Disable
Midi -> DeviceId 1
Midi Control -> LoPage SysEx
Midi Control -> HiPage SysEx
------------------------------------
Under Cubase Sx: set the tempo track to 4 bpm, midi IN and OUT to my midi interface, Channel 1.
RESULT: press play, the sequencer starts and I can see a little "C" between "1" and "A0" (where A0 is the first of bank A),the little "C" keep flashing on even if i stop the sequencer....nothing happens....bank A ramains the same.
p.s. the error "sysex wrong checksum" does not display....
Under SoundDiver: have raised timeout setting to 800 ms, send pause to 350 ms, play delay to 200. If I load the midi file or the sounddiver file is the same: "sysex with wrong checksum" ...a little "SE" appears between "1" and "A0"....i notice that the sounds are changed but they are not labelled,for istance I can see the names of every sound into sounddiver but everytime i try to transmit dispays the usual fuckin' error!!!
I start thinking about my midi interface....broken???....
obviously I connect midi IN of the midi interface to midi OUT of the Virus
and midi OUT of the midi interface to midi IN of the Virus.....i suppose this is correct....
I have also tried several changes to my settings doing a lot of combinations...nada de nada!!
waiting for an angel.....
bye byez
__________________
:::::::::.............L.A.M.U..............::::::::::
G.0.T.H. 1ndu5tr1al EBM
check out : www.hd027.tk
|