Ok, I found
Effect Send (Reverb) as available assignment.
So there are three way to set this up:
- Assign Soft Knob to Effect Send (Reverb)
- Assign Modulation Matrix Slot 2 to Controller 12, Amount 1 to +63 and send to Reverb Send, assign Soft Knob to Controller 12
- Assign Modulation Matrix Slot 2 to 10% Constant, Amount 1 to 0 and send to Reverb Send, assign Soft Knob to Assignment 2 Amount 1
In all these three scenarios the assigned Soft Knob works differently but correct:
- Soft Knob shows the stored and current value in db and only adjusts if stored value is touched
- Soft Knob shows the stored and current value (-64 .. +63) and only adjusts if stored value is touched
- Soft Knob shows the current value and immediately starts adjusting, as if it was an external MIDI controller
Seems just fine to me.
BTW, I'm using a Darkstar TI2 with OS 5.1.3.0, and did the above on the hardware without VC.