Is it just my Virus C or is LF3 Buggy

[deep6ixx]

I have had my virus for over a year now and i have been spending more time with it and getting better with building custom patches from scratch. I have noticed in the past using the LFO 3 assignment leds will not light up after i assign lfo amount to a setting. And even after assigning amount to a setting on the LFO 3 assignement list it would not hold my changes. I would switch down the list and it would not keep them. Very strange and im concerned this unit is defective and i just never understood my virus to ever know. I see that all the premade patches that use LFO3 work fine though.

[ben crosland]

No, it's not defective - that's how LFO3 works. You can only assign one destination to it at a time, unlike LFOs 1+2, so when you switch down the list, you are changing the one destination it is applied to. As you have noticed, the LEDs only light up at all if you have altered the value of Assign Amount.

[deep6ixx]

Ben thanks again. I noticed last night this was true once i started to compare the other patches. But thanks for clearing that up! Im stoked i have a healthy Virus if there could be a good virus.