Very serious MIDI question for ACCESS

[Yornav]

Hi

I noticed some very strange thing...

when I use the virus TI in remote mode to record knob movement. I noticed that when I used my M-audio ozonic. There was a difference in accuracy... my ozonic was drawing more points, just a little bit more... wich resulted in smoother lines....

Was this latency???

2 hours later I discovered some more weird I could not believe... ok I am not a pro... But when I was looking to move the sliders in virus control (mixer slider) I locked soft knob 1 down on channel volume (wich was named part volume in control when I over moused it and took me 1hour to find) whatever... When I start using the knob... I emediately start noticing that the movement was not smooth... I looked down on the little screen of the virus to see if the knob was jittering the numbers it was sending. but that was ok... tried soft knob 3, it was the same... the slider jumps a little bit when i turn the knob, it jitters... and is therefore unuseable!!!

Now I just got the idea to try my ozonic on it... I put cc 7 on a knob and via routing in ableton the slider was moving... unbelievable smooth.

I have no idea what this could be... It seems (what I think) that the MIDI messages inside the VIRUS are in (maybe) conflict whit some other processing things... but notice that nothing is playing a single note...

Very weird that a controller (ozonic) sends a cc through fire wire to pc and then usb to the virus and is WORKING BETTER THEN HIS OWN KNOBS...

I hope someone can teach me something about this... Access?

Or did I discover somekind of bug?

Kindly regards

Yornav

ps: I have a TI2 desktop os3