Convertor switching on the TI series? - The Unofficial Access Virus & Virus TI Forum

		The Unofficial Access Virus & Virus TI Forum - since 2002 > Discussion concerning Access products > General discussion about Access Virus
Convertor switching on the TI series?

General discussion about Access Virus Discussion about Virus A, B, C and TI.

Thread Tools

Search this Thread

Display Modes

16.02.2005, 01:23 PM

Targon

Complete Newbie

Complete Newbie

Join Date: 14.05.2002

Posts: 18

Convertor switching on the TI series?

The spec's say 192k 24 bit, thats wonderful an all, but, analog synths never had 24bit 192k outputs.

So did Access make it possible to set the sample rate to say 22, 44 or 48 k an the bit rate to either 12 or 16 bit either globally or any individual output?

Best

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MIDI Controllers resetting after switching Channels in Logic	Eric Miles	Trouble with your Access Virus?	2	06.02.2006 01:50 PM
Switching between parts in multi mode	jonp7	Trouble with your Access Virus?	0	12.05.2004 11:59 AM
Trouble switching from Multi mode to Single	Smag	Trouble with your Access Virus?	4	04.01.2004 05:54 AM
New Virus C Series OS!!!	marc	General discussion about Access Virus	29	13.11.2003 03:50 PM
switching banks/presets	mighty	Trouble with your Access Virus?	4	23.10.2003 04:03 PM

All times are GMT. The time now is 07:58 PM.