Stanton SCS.3d driver

[Paprika]

Hello guys,

I'm doing a DaRouter preset for SCS.3d (certainly SCS.3m fits to this purpose better, perhaps I will buy that one too later) to control Virus. That is a tough work with Bome's Midi Translator, but I have already succeeded to map OSC1 CuttOff knob to S1 slider The next step is to reflect the actual CutOff value on S1 leds. After that I am about to map all soft knobs and the rest from Easy Page, a quick access to different filter modes and routings is a later target.

Overall all this is to substitute a luck of endless knobs which Access just don't want to integrate. It's always nice to see what the knobs' values are and tune them with relevant adjustments rather than those instant Jump or Snap/Release/etc modes.

If anyone there has the same device, we could coup and decide what would be the best mapping layout, different modes and so on.