Virus TI ReMOTE Templates v0.7 - Now with sysex

[djflan]

I have been working on a template for the TI Snow/TI series(strain ) for the Novation ReMOTE midi controllers. I have found an incomplete list of CC#s that I am using to map the TI.

The mapping is nearly complete...The Vocoder and input follower is not mapped, nor the mod matrix. I welcome anyone with a ReMOTE midi controller to improve upon these. Perhaps someone knows the sysex required for additional functions.

Update: Using Midi-Ox and a hex editor I found some sysex controls...hope you guys like this...its taken a lot of work

The controlls are as follows (left to right):

Page 1: ------------------------------

Top Left Row Buttons:
(1)Osc 1 Mode

Top Left Encoders:
(1)Osc 1 Shape, Index. HS Density
(2)Osc 1 Wave #, Wavetable
(3)Osc 1 Pulse Width, Hypersaw Detune
(4)Osc 1 Semitune
(5)Osc 1 Keyfollow
(6)Osc 1 Sync Frequency
(7)Osc 1 Detune
(8>Osc 1/2 Balance

Mid Left Row Buttons:
(1)LFO 1 Mono/Poly Select
(2)LFO 1 Envelope Mode

Lower Left Pots:
(1)LFO 1 Shape
(2)LFO 1 Rate
(3)LFO 1 Contour
(4)LFO 1 Trigger Phase
(5)LFO 1 Key Follow
(6)LFO 1 +Osc 1 Pitch
(7)LFO 1 +Osc 2 Pitch
(8>LFO 1 Pulse Width

Drum Pads: Not Mapped

Top Right Sliders:
(1)Amp Attack
(2)Amp Dcay
(3)Amp Sustain
(4)Amp Release
(5)Amp Sustain Slope
(6)Transpose
(7)Patch Volume
(8>Panorama

Mid Right Row Buttons: Not Mapped

Lower Right Row Buttons: Not Mapped

Page 2: ------------------------------

Top Left Row Buttons:
(1)Osc 2 Mode

Top Left Encoders:
(1)Osc 2 Shape, Index. HS Density
(2)Osc 2 Wave #, Wavetable
(3)Osc 2 Pulse Width, Hypersaw Detune
(4)Osc 2 Semitune
(5)Osc 2 Keyfollow
(6)Osc 2 FM Amount
(7)Osc 2 Filter Envelope>Pitch
(8>Osc 2 Filter Envelope>FM

Mid Left Row Buttons:
(1)LFO 2 Mono/Poly Select
(2)LFO 2 Envelope Mode

Lower Left Pots:
(1)LFO 2 Shape
(2)LFO 2 Rate
(3)LFO 2 Contour
(4)LFO 2 Trigger Phase
(5)LFO 2 Key Follow
(6)LFO 2 +Cutoff 1
(7)LFO 2 +Cutoff 2
(8>LFO 2 Shape 1+2

Drum Pads: Not Mapped

Top Right Sliders:
(1)Filter Attack
(2)Filter Dcay
(3)Filter Sustain
(4)Filter Release
(5)Filter Sustain Slope
(6)Filter 1 Key Follow
(7)Filter Envelope Amount
(8>Filter 1/2 Balance

Mid Right Row Buttons:
(1)Filter 1 Mode
(2)Filter Routing
(3)Filter Envelope 1 Polarity Select
(4)Filter Envelope 2 Polarity Select
(5)Cutoff Link On/Off
(6)FM Mode Select

Lower Right Row Buttons: Not Mapped

Page 3: ------------------------------

Top Left Row Buttons: Not Mapped

Top Left Encoders:
(1)Osc 3 Mode
(2)Osc 3 Semitone
(3)Osc 3 Volume
(4)Osc 3 Detune
(5)LFO 1 Resonance
(6)LFO 1 Gain
(7)LFO 2 FM Amount
(8>LFO 2 Panorama

Mid Left Row Buttons: Not Mapped

Lower Left Pots:
(1)LFO 1 Clock Select
(2)LFO 2 Clock Select
(3)LFO 1 Target Assign
(4)LFO 2 Target Assign
(5)LFO 1 Amount
(6)LFO 2 Amount
(7)Sub Osc Volume

Drum Pads: Not Mapped

Top Right Sliders:
(1)LFO 3 Clock Select
(2)LFO 3 Rate
(3)LFO 3 Shape
(4)LFO 3 Mode
(5)LFO 3 Key Follow
(6)LFO 3 Fade Amount
(7)LFO 3 Target Assign
(8>LFOO 3 Amount

Mid Right Row Buttons: Not Mapped

Lower Right Row Buttons: Not Mapped

Page 4: ------------------------------

Top Left Row Buttons:
(1)Delay Type Select

Top Left Encoders:
(1)Delay Send Amount
(2)Delay Feedback
(3)Delay Mode
(4)Delay Clock Select
(5)Delay Time Amount
(6)Delay Color/Frequency
(7)Delay Mod Rate
(8>Delay Modulation/Depth

Mid Left Row Buttons: Not Mapped

Lower Left Pots:
(1)Delay Mod Shape
(2)Delay Ratio Select
(3)Delay Bandwidth
(4)Not Mapped
(5)Unison Voices Select
(6)Unison Detune
(7)Unison LFO Phase
(8>Unison Pan Spread

Drum Pads: Not Mapped

Top Right Sliders:
(1)Delay Left Clock Select
(2)Delay right Clock Select
(3)Not Mapped
(4)Chorus Mix
(5)Chorus Delay
(6)Chorus Feedback
(7)Chorus Mod Rate
(8>Chorus Mod Depth

Mid Right Row Buttons:
(1)Chorus Mod Wave Select

Lower Right Row Buttons: Not Mapped

Page 5: ------------------------------

Top Left Row Buttons:
(1)Reverb Mode
(2)Reverb Type

Top Left Encoders:
(1)Reverb Send Amount
(2)Reverb Clock Value
(3)Reverb Time
(4)Reverb Dampening
(5)Reverb Color
(6)Reverb Pre-Delay
(7)Reverb Feedback

Mid Left Row Buttons: Not Mapped

Lower Left Pots:
(1)Lo-Eq Frequency
(2)Lo-Eq Gain
(3)Mid-Eq Frequency
(4)Mid-Eq Q-Factor
(5)Mid-Eq Gain
(6)Hi-Eq Frequency
(7)Hi-Eq Gain

Drum Pads: Not Mapped

Top Right Sliders:
(1)Distortion Type
(2)Distotion Mix
(3)Distortion Intensity
(4)Distortion Treble Boost
(5)Distortion High Cut
(6)Distortion Quality

Mid Right Row Buttons: Not Mapped

Lower Right Row Buttons: Not Mapped

Page 6: ------------------------------

Top Left Row Buttons:
(1)Character Type
(2)Phaser Stages

Top Left Encoders:
(1)Character Intensity
(2)Character Frequency
(3)Phaser Mix
(4)Phaser Frequency
(5)Phaser Feedback
(6)Phaser Mod Rate
(7)Phaser Mod Depth
(8>Phaser Spread

Mid Left Row Buttons:
(1)Frequency Shifter Type

Lower Left Pots:
(1)Frequency Shifter Mix
(2)Frequency Shifter Frequency
(3)Frequency Shifter Stereo Phase
(4)Frequency Shifter Shape Left
(5)Frequency Shifter Shape Right
(6)Cutoff
(7)Resonance

Drum Pads: Not Mapped

Top Right Sliders:
(1)Arp Pattern
(2)Arp Resolution
(3)Arp Note Length
(4)Arp Swing Factor
(5)Tempo

Mid Right Row Buttons:
(1)Arp Mode
(2)Arp Octaves
(2)Arp Hold On/Off

Lower Right Row Buttons: Not Mapped

The XY pad is mapped to cutoff in +y and resonance in +x

---- to install:
NOTE: Template includes pages to allow easier editing, thus templates must be sent in sequential order (e.g) template for page 1 stored as template #1, template for page 2 stored as template #2...etc

To change pages while using controller, press the side buttons on the controller(row select). Mutiple selections will trigger page changes. The LCD will reflect these changes.

Let me know if you find any bugs, etc.

I will update this thread as I map more controlls

Enjoy
-Daniel

[SecretHero]

thanks man...

[ens]

wow this looks really awesome! for some reason though i can't download this. pops up with forum sign in, but i'm already signed in... anyway can i download this from somewhere else or get this file sent to me to try out. been mapping out my own template for the sl but all i could find was Virus C cc#'s. this would be so sweet with the sysex mappings!

can't believe nobody else has responded to this thread.

[djflan]

pm me your email and ill send it to you

[ShortBus]

Great layout but I cant get the sysex asighnments to work? Thanx T.J.

[djflan]

If you are using the old template editor, there is a bug that prevents this from working. Download this version and try it.

http://www.hotlinkfiles.com/files/25...3.8517.exe.zip

[ShortBus]

I tried everything for some reason it still wont let me modify any of the sysex peramiters. Please help, I do like the layout.

[igor_stravinski]

This is timely. i just purchased a 37SL and could not get sysex to work. The Access manual mixes hex and decimal. Thanks for the effort and it is working smoothly for me.

There are still some features to the virus that do not have a documented sysex message associated with them. In particular the level and duration of the steps of the arp that you can adjust through virus control. I would love to be able to selectively turn off different steps in a live performance. This is not unlike how the microKorg or R3 works (as well as numerous drum machines). Any thoughts on whether these parameters are accessible?

I would also like to see those steps assignable to a synth parameter in the matrix section as well but that would be a feature Access would need to add.

[djflan]

I was unable to find sysex strings for allow user editing for the arp...that is possible in a furture version. I'll work on another page for the mod matrix.

[igor_stravinski]

djfan:
are you willing to post the sysex messages that you uncovered. These are not documented anywhere in the Virus TI manual and some of them are different that what is in the Virus C manual. This would be very helpful for those who would like to use them in another controller or within sequencers or to script to.

Something as simple as column 1 parameter, column 2 sysex. But it could also be broken up by pages.

thanks so much for your effort

.m