1.0.8updt is out

[The girl next door]

Originally Posted by ben crosland

Before installing it, try going to Control Panel>Add/Remove Programs and removing the TI Software.

There have been some reports on the ampfea list that this is necessary for PC users.

BEN CROSLAND, you F***ing star......WE LUV YOU.
Is there anything this Geezer don't know..???
Have a good Christmas mate...
All the best

[dr. orange]

Originally Posted by The girl next door

Have a good Christmas mate...
All the best

yes, that's what I also wish you ben as well as all the forum users here!!!

and for those who still are angry with me having called you "alphatesters", sorry, that wasn't kind of me...

merry christmas you all

[dekenno]

Mine?s just unpacked, installed and upgraded and says 1.0.8

[rsformatc]

1.08 has completely fixed my audio export problem!!

This time I am certain.

I have performed about a dozen exports at diferrent bit and sample rates and on different parts playing together and on their own with and without other VSTs - all absolutley 100% sample accurate!!! As much as I tired to break it the timing held!

I am so pleased, this has been bothering me for ages. Thanks Access for a wonderful XMas present!

One negative however is while doing all my testing the my one arp part flipped out on me and and I had to reset the TI. (I am using pre-roll by the way.)

[Guzzy]

All OK here also!


--------------------------------------------------------------------
1.08 take:
http://home.online.no/~gosather/songs/screamarp_2.mp3

[Doc Jones]

Originally Posted by rsformatc

1.08 has completely fixed my audio export problem!!

This time I am certain.

Very cool. Just downloading it right now.

[diy]

After 1.0.8 midi timing seems to be tightier but with specific patches especially these buried under heavy delay I get arp drift. I control my TI via midi yet as I think its too early for virus control to be 100% bugless. I will wait,until then, enjoy midi dumps..

[Hollowcell]

It's looking good so far guys. Really glad to hear it!

Now that Access will have more time. How about incorporating the hypersaw into the C series?

C'mon Access, you know you wanna.

[Smag]

Installed mine and it says 21 Dec 1.0.8 in the splash screen....... When I finally get to boot it up. Arrgghh having ongoing issues where the screen is blank and hangs, takes a few times and a bit of fiddling to get going - still happening in the 1.0.8 update. Just had an amazing arp going - this really has got way more balls than my C had, but 3 minutes into the arp, disaster struck and a shitty noise came out, prompting me to reboot and lose a solid slab of techno I'd just created.

Haven't even tried the Virus Control yet, just trying to get things going a la Virus C.

Shit and corruption....