Virus Ti - using stereo output pairs for 2 sets of monitors

[kevscales]

Hi, Im just wondering if it's possible to toggle/switch between the analogue output pair from within cubase. So I can check my mix on 2 different sets of monitors as I'm working. I use the virus ti as my soundcard and I'm using output pair 1 straight into my mackies at the moment for monitoring the main mix, but want to send output pair 2 to another set of speakers and switch between them as and when i want to. I wish to be able to do this from inside cubase (5), or at least do it without closing cubase down. Is this possible ?
Thanks.

I7, windows 7. Cubase 5. Virus Ti 2 polar.

[mildheadwound]

In single edit mode, you can set the surround outs to output2 L+R, then just set your balance to the middle to get both channels, or pan to either one independently. Basically the surround sound will act as signal splitter when not in use with the patch already. Not positive, but surround pan may even have a midi cc#, if you check the virus' cc maps. If so, it could even be animated by cubase.