|
|||||||
| Trouble with your Access Virus? Here you can get help when you have trouble or just don't know what to do. |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
20.12.2004, 04:07 PM
|
|||
|
|||
Shape knob problem
Hi all.
Yesterday I noticed the shape knob in my virus jumps a little: it works perfectly, but when I reach 60 (coming from 127), it jumps to 55, and the same happens once I reach 50 (it goes to 45). I can get the inbetween values if I try to several times. Its quite noticeable if you do a sweep with that knob, and it worries me as I'm thinking in selling my VC to get a VTi. I dont want to sell it if it isnt 100% working. ?is there any solution? ?should I take it to repair? ?will this cost too much? My VC has no guarantee left. Thanks in advance. 
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | Search this Thread |
| Display Modes | |
Threaded Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TI - Knob response problem - could someone compare with me. | Numina | Trouble with your Access Virus? | 11 | 07.11.2019 08:52 AM |
| recording knob sweeps in cubase sx3 | vortex1660 | General discussion about Access Virus | 2 | 27.10.2007 02:04 AM |
| Recording knob Tweaks: is there an easier way? | iRaq | General discussion about Access Virus | 1 | 01.04.2007 07:27 AM |
| Soft knob automation.....? | addicted2tech | General discussion about Access Virus | 3 | 03.07.2006 09:05 PM |
| My knob has gone stiff | Smag | Studio equipment | 12 | 13.06.2006 02:42 PM |
All times are GMT. The time now is 02:24 PM.
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Skin Designed by: Talk vBulletin
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Skin Designed by: Talk vBulletin
Copyright ©2002-2022, Infekted.org
 |
 |